Features
Outside patios are great for dining and entertainment. However, when it's too cool in the shade or just not warm enough, wouldn't it be great if you could heat the area to enjoy the outdoors? Extend your patio use throughout the cooler seasons when you provide heaters for your customers, or for the home deck.
- 1500 Watts
- Patented IR Lens increases output 3 to 5 times versus conventional heaters.
- ETL certified electric heater.
- Durable, weatherproof casing.
- 9 foot grounded cord included.
- Wall mount with on/off switch.
- No open flames or carbon monoxide emissions.
- Quiet and odorless heat. No venting required.
- Minimal clearance requirements.
- Made in U.S.A.
- Model: HZE-1500W
Important Hotzone Electric Patio Heater Information
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before installing and using this heater.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- Never locate heater where it may fall into water or combustibles.
- Do not install closer than the minimum clearances to any surface.
- Install heaters so that items in the infrared beam of the heaters do not overheat.
- A heater has hot and/or arcing and/or sparking parts inside. Do not use it in areas where gasoline, paint, flammable liquids or highly combustible dusts are used or stored.
- If the unit is installed in proximity of tents or awnings, please be sure that recommended installation heights and clearances are respected, and that the heater is not in direct contact with the tent or awning material.
- Allow for user angle and directional adjustment, if possible, as heating requirements change. The optimal mounting angle is between directly down and 45°. Comfort is best obtained with the heater off to one side and angled at 35°.
- Heater must be installed according to NEC and all local electrical codes.
- Be sure the electrical supply is adequate for the heater (voltage/amps/phase) while allowing for line losses.
- The heater should always be connected to a grounded circuit. If a GFCI socket is not available, GFCI adapters can be purchased locally.
- Never use an extension cord with this appliance.
- To avoid burns, do not touch hot surfaces with bare skin. Keep combustible materials at least 48" from the front of the heater and avoid contact with the sides, back and top.
- Extreme caution is necessary when any heater is used in areas with children or persons that may not have reasonable judgment around appliances. The heater should never be used unattended.
- Do not insert or allow foreign objects to enter the heater or block any ventilation openings as this may cause an electric shock or fire, or damage the heater. Do not cover or obstruct the heater while operating.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to dealer for examination, electrical or mechanical adjustment, or repair.
- Burned-out elements cannot be repaired and must be replaced. The element can be replaced by the user; please follow the instructions provided.
- Always disconnect the heater from the main electrical supply during installation and/or replacement of the heater element.
|
